CNC Shield V3.0 For Arduino Uno
Original price was: 120.00 EGP.99.00 EGPCurrent price is: 99.00 EGP.
The Arduino CNC 3D Printer Shield V3.0 is developed especially for those beginners who are interested in CNC or 3D printers. This expansion board can be used for engraving machines, and 3D printers with a total of four slots, and can drive four A4988 or Drv8825 stepper motor drivers.
| Weight | 0.03 kg |
|---|---|
| Dimensions | 6.8 × 5.3 × 1.8 cm |
2 in stock
CNC Shield V3.0 For Arduino Uno
Shield for Arduino, which allows you to build a 3D printer driver or other CNC equipment’s driver. Thanks to the four connectors for the motor driver, e.g. A4988, it facilitates the use of stepper motors. The board is compatible with G-code interpreter, GRBL. It has derived inputs and inputs of the movement direction of the steps for four drivers, inputs for end sensors END STOP and outputs of I2C bus and UART.
The module is compatible with Arduino Uno and Mega- Arduino boards can be purchased separately.
With the ability to connect up to 4 stepper motors and a GRBL interpreter, creating your own 3D printer has never been easier. Shield is assembled – requires no soldering. A motor driver, for example A4988, must be purchased separately.
Specification: CNC Shield – 3D printer driver – Shield for Arduino
- Voltage motor power supply (depending on driver): from 12 V to 36 V
- Power supply voltage is connected via a screw connector ARK
- Operating voltage logic signal: 5 V
- Connectors of the motor driver compatible with A4988 and the like
- Output signals: STEP and DIR signals for the four drivers: X.STEP / Y.DIR, X.STEP / Y.DIR, Z.STEP / Z.DIR, A.STEP / A.DIR
- Output connectors, UART and I2C
- Inputs for end sensors, limit switches type END STOP: Z+ / Z-, Y+ / Y-, X+ / X-,
- Embedded capacitors 100 uF and 50 uF 8 mm
- Resistors 10 ohms
- Outputs for motors
- Compatible with GRBL 0.8 c
Useful links
Related products
WeMos D1 ESP8266 WiFi Board (UNO Based)
The ESP8266 D1 R1 WiFi board utilizes the ESP8266 WiFi enabled processor, and puts it onto an Arduino Uno board footprint. It provides a way to work with the ESP8266 in a familiar setup and does not require a breadboard in order to make interconnections since it has the typical on-board female headers. It will also work with some Uno shields that have compatible I/O pin-outs.
WIFI Serial Module ESP-01 Adapter Board (3.3V 5V)
The use of an ESP8266 with Arduino requires logic level translation of the UART signal, as provided by this easy 3.3 V – 5 V adapter. It makes the ESP-01 ESP8266 WiFi module the easiest WiFi transceiver for your Arduino (5 V).
Reviews
There are no reviews yet.