Flexible Shaft Coupler 8x10mm
GT2 Idler Pulley 5mm Bore (Toothless, 10mm Width)
GT2 Idler Pulley 20 Teeth 3mm Bore (6mm Width)
- Product type: GT2 Pulley
- Material: Aluminum alloy
- Tooth Profile: GT2
- No. of teeth: 20
- Bore: 3mm
- Suitable Belt: 6mm
GT2 Idler Pulley 20 Teeth 5mm Bore (6mm Width)
- Product type: GT2 Pulley
- Material: Aluminum alloy
- Tooth Profile: GT2
- No. of teeth: 20
- Bore: 5mm
- Suitable Belt: 6mm
Sliding Tee Nut M6 for 2020 Aluminum Profile
Sliding Tee Nut M3 for 2020 Aluminum Profile
Solid V Wheel
Laser Receiver Module
eSUN Soft Pink PLA+ 3D Filament 1.75mm 1kg
PLA+ is a type of 3D printer filament that is based on standard PLA, but with extra additives to enhance a wide range of qualities. It addresses many of the common problems that PLA presents, such as the brittle nature, low elongation breaking point, as well as layer adhesion. The only area in which regular PLA beats PLA+ is in tensile strength, although it is a slight difference, and is far outweighed by the plethora of benefits.
eSUN Lilac PLA+ 3D Filament 1.75mm 1kg
PLA+ is a type of 3D printer filament that is based on standard PLA, but with extra additives to enhance a wide range of qualities. It addresses many of the common problems that PLA presents, such as the brittle nature, low elongation breaking point, as well as layer adhesion. The only area in which regular PLA beats PLA+ is in tensile strength, although it is a slight difference, and is far outweighed by the plethora of benefits.
STM32F103C8T6 ARM Minimum System Development Board
- Number of pins: 48
- Kernel: ARM Cortex-M3
- Operating frequency: 72MHz
- Storage resources: 64K Byte Flash, 20KByte SRAM
- Interface Resources: 2x SPI, 3x USART, 2x I2C, 1x CAN, 37x I / O ports,
- Analog-to-digital conversion: 2x ADC (12-bit / 16-channel)
- Timers: 3 general timers and 1 advanced timer
- Debug Download: Support JTAG / SWD debug interface to download, support for IAP.
- RT9193: 3.3V regulator chip, a maximum output of 300mA.
14D471K Metal Oxide Varistor MOV (14mm Disc)
14D681K Metal Oxide Varistor MOV (14mm Disc)
E3D Volcano Nozzle 0.2mm (Stainless Steel)
- Material: Stainless steel for corrosion resistance and durability.
- Nozzle Size: 0.2mm for high-detail, fine-resolution 3D printing.
- Filament Compatibility: Designed for 1.75mm diameter filaments.
- Thread Type: Standard M6 external thread.
- Hotend Compatibility: Extended Volcano heater block style (not compatible with standard V6 blocks)
10D681K Metal Oxide Varistor MOV (10mm Disc)
10D471K Metal Oxide Varistor MOV (10mm Disc)
10D431K Metal Oxide Varistor MOV (10mm Disc)
10D561K Metal Oxide Varistor MOV (10mm Disc)
